# Cycles to Use

# Cycles to Use

The default value is 3 (for cycleAnalyzer) and 5 (for cycleProjector) with a valid range from 1 to 35.

This parameter controls the number of cycles that will be used to create the indicator output display.

In cycleAnalyzer, this will control the number of individual cycles that are displayed in the indicator pane. In cycleProjector, this will control the total number of cycles used to create the synthetic time series that will then be back-plotted as well as projected into the future.

This parameter is used in conjunction with the Cycle Primary Sort and Cycle Secondary Sort to control specifically which cycles are included in the display.